Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
Run-In before Operation
For optimum performance, allow your new
Flexible Driver attachment to run at high
speed on
your rotary tool in a vertical position for 2
minutes before use (Fig. 7).
Disengagement of the Flexible Driver
The flexible shaft may become disengaged
if the motor of your rotary tool is not elevated
Higher than the working end of the Flexible
Driver.
Flexible Shaft Lubrication
The Flexible Driver should be lubricated
after every 25-30 hours of use. To lubricate,
Unscrew the Flexible Driver assembly from
the motor housing. Pull the center core out
of the Flexible Driver assembly. Wipe a
very thin film automotive wheel bearing
grease on to the center core and reinsert it
back into the shaft. To prevent damage to
tool do not over grease shaft.
Too much grease will cause the unit to
overheat.
Reattach the Flexible Driver to the rotary tool.
Cleaning, maintenance
Always pull out the mains power plug before starting any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor housing free of dirt and
dust as far as possible. Wipe the equipment with a clean cloth or blow
it with compressed air at low pressure.
We recommend that you clean the device immediately each time you
have finished using it.
Clean the equipment regularly with a moist cloth and some soft soap.
Do not use cleaning agents or solvents; these could attack the plastic
parts of the equipment. Ensure that no water can seep into the device.
Maintenance
There are no parts inside the equipment which require additional maintenance.
Environmental Protection
Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice
- 17 -
Publicité
