Publicité
Les langues disponibles
Les langues disponibles
Flexible Driver Attachment
·
Safety Rules for Flexible Driver
Do not operate the flexible shaft with a
sharp or multiple bends. Ensure that there
are no sharp residual bends or kinks in
the Flexible Driver before the operation.
Over bending the shaft can generate excessive
heat on the jacket or hand piece and may
cause the Flexible Driver to disengage from
the tool. The minimum recommended
bend radius is 6".
Always hold the hand piece firmly in your
hands during the start-up. The reaction
torque of the motor, as it accelerates to full
speed, can cause the shaft to twist.
Not for use with router bits or other large
diameters (1" or larger) bits. Large diame-
ter bits can cause kickback and loss of
control when used with the Flexible Driver.
Do not remove end ferrule while tool is
running. The cable will become loose from
the jacket and will uncontrollably whip or
lash around.
Installation Instructions
It is extremely important to carefully read and follow the directions below to
assemble the Flexible Driver to your rotary to ensure the tool will function
properly.
To properly attach the Flexible Driver to the rotary tool, THREE items must
be removed from the tool: the nose cap, collet nut and collet.
1.
Press the Shaft lock button 1, unscrew and remove the collet nut or 2
(Fig. 1).
2.
Unscrew the nose cap 3 from the tool (Fig. 2).
3.
Remove the collet 4 (Fig. 3).
4.
Install the driver cap 5 on the motor shaft 6 and tighten (Fig. 4).
To prevent damage to tool, do not overtighten driver cap. Tighten the
driver cap finger tight and then tighten an additional 1/3 turn with the
wrench.
5.
Attach by screwing the collar of the Flexible Driver 7 to the rotary tool.
Make sure the square end of the center core engages the square hole
socket in the driver cap (Fig. 5).
6.
Replacing bits(Fig. 6 and Fig. 7): Hold down 11 to loosen 2, then put the
accessories into 2 and tighten with the equipped wrench. When using
Flexible Driver, it is recommended that the diameter of the accessories
can't exceed 10MM.
- 15 -
6"RADIUS
Publicité
