Publicité
Les langues disponibles
Les langues disponibles
Cutting guide
The cutting guide comes completely assembled and ready to use on a
variety of materials up to 20mm thick. Always hold the tool firmly, using a
slow steady pressure to guide the tool through your work. The speed of the
tool will do the work.
IMPORTANT: Always cut in clockwise direction except when following a
template (outlet box), then cut in counter clockwise direction.
Installation Instruction of the Cutting Guide Attachment
Step 1 & 2) Remove the collet nut and then the housing cap from the end
of your rotary tool.
Step 3) Place the collet nut loosely on the end of the rotary tool and insert
the cutting bit. Tighten collet nut.
Step 4) Thread the Cutting Guide Attachment onto the exposed housing
threads on the rotary tool.
Step 5) Adjust the attachment to the desired cutting depth.
Step 1
1
Step 3
2
Step 5
Step 2
2
Step 4
4
- 13 -
3
Publicité
