APEX FORGE M6 Pro Mode D'emploi page 11

Insert the shank of the accessory into the collet as deep as possible.
With the shaft lock (A) engaged, tighten the collet nut (D) with the provided
wrench (E) until the accessory shank is gripped by the collet. Avoid
excess tightening of the collet nut (D).
Removing Accessories
Unplug the rotary tool.
With the shaft lock (A) engaged,
loosen the collet nut (D) with the
provided wrench (E).
Remove the accessory.
Using Mandrels
The most common types of mandrel to use with this tool are the standard
mandrel which is used with cutoff discs, grinding wheels, emery wheels,
and cut-off wheels. Screw mandrels are used with polishing wheels and
polishing drums. Drum mandrel are used with sanding drums.
To install:
Unplug the rotary tool
Install the mandrel.
If using the standard mandrel:
Press and hold the shaft lock button (A).
Insert the slot end of the provided wrench
into the slot on top of the mandrel and
unscrew.
Remove mandrel screw and washer.
Place desired accessory over mandrel shaft
and align accessory hole with mandrel
hole.
Insert mandrel screw with washer through
the accessory and mandrel shaft holes.
NOTE: The mandrel washer should be placed
between the mandrel screw and the accessory.
Tighten using provided wrench.
If using the drum mandrel:
Align appropriate sized sanding drum
A
E
- 09 -
D