Beurer HT 22 Mode D'emploi page 17

Using the device
1. Comb your hair with a large-toothed comb to get rid of any
tangles. Your hair should be clean, dry and free from styl-
ing products.
2. Slide the plate locking system
vice (see Figure
is inserted.
3. Switch on the device using the ON/OFF button
ON/OFF button
correct direction of use depends on which hand you are us-
ing or which side of your head you are using the device on.
The green arrows in the display
floor during use.
4. Part the hair into individual sections that are approximately
2 to 3 cm wide.
5. Hold a section taut and place it between the plates near the
roots (see Figure
6. Slowly move the device from the roots to the tips in a fluid
motion (see Figure
and land in the collection tray
7. To switch off the device, press the ON/OFF button
the green arrows disappear from the display.
8. Press the two plates together and slide the plate locking
system
3
5. CLEANING AND MAINTENANCE
WARNING
Risk of injury/crushing! Switch off the device before removing
the collection tray
cutting chamber from behind while the device is switched on!
). Make sure that the collection tray
B
to select the correct direction of use. The
2
).
C
). Dry and broken hair tips are cut off
D
upwards.
from the device. Do not reach into the
5
3
down to unlock the de-
should point towards the
1
.
5
17
5
. Use the
2
until
2