Fluke Networks MicroMapper Manuel Utilisateur page 7

High Voltage Protection
Do not connect M
damage the unit.
Strong radio frequency fields may cause inaccurate
readings.
Do not open the unit or attempt to repair in case of
malfunction. Please send it back to your distributor for
repair or replacement.
M M
ICRO
1. Slide the switch on the right side of
M M
ICRO APPER
2. Connect the cable to the M
(To send a tone into a patch panel, connect one end
of the included patch cord to the M
RJ45 jack and the other end to a jack on the panel.)
3. To generate tone 1, press and quickly release the
(TEST) button.
4. To generate tone 2, press and hold the
button for two seconds.
5. Use the M
The signal reception is strongest near the cable
under test.
6. Slide the switch on the right side to the Off position
to discontinue the tone. (Always power the unit off to
prevent battery drain.)
M M
ICRO APPER
M
ICRO
'
APPER S
to the Toner position.
P
ICRO ROBE
TM
to a live circuit as it may
APPER
Toner Operation
ICRO
to trace the connected cable.
M 's RJ45 jack.
APPER
M
ICRO APPER
ENGLISH - 4
's
(TEST)