Polaris TANDEM Mode D'emploi page 13

TANDEM TRAILER
KIT PN 2878231
5. Position the main axle reinforcement (#13) (note : make sure that the tab is against the side panel) and fasten
using
(8) M8-1.25 X 20mm
tighten at this time). Slide the
main axle (#7). Insert the
does not exceed the diameter of the shim (#21) once folded in place) and install the plastic cap (#25).
Tighten firmly all screws and nuts installed in steps 2 and 3.
GOOD
6. Insert the
46mm X 26mm X 1.5mm
and the
46mm X 26mm X 1.5mm
the end of the main axle (#8) (make sure that the cotter pin does not exceed the diameter of the shim (#21) once
folded in place) and install the plastic cap (#25) on each axle of the swingarm (#8).
Verify that the tire pressure is correct.
Repeat steps 4 to 6 for the opposite side.
GOOD
7510316
A-7510316 Rév. B
Allen socket machine screws (#17) and
shim (#23) and the
35mm X 26mm X 3mm
cotter pin (#15) at the end of the main axle (#7) (make sure that the cotter pin
4.5mm
BAD
shim (#21), the sleeve (#22), the wheel (#14), the
shim (#21) on each axle of the swingarm (#8). Insert the
BAD
- 5 -
nylock flange nuts (#16) (do not
(8) M8-1.25
shim (#21) on the
46mm X 26mm X 1.5mm
Tab
35mm X 26mm X 3mm
cotter pin (#15) at
4.5mm
Imprimé en Chine / Printed in China
shim (#23),