Bandolier Waistbelt; Dv & Facemasks; Airline Checks - Scott Safety Ras Asbestos Instructions D'utilisation

RAS ASBESTOS
3.2

BANDOLIER WAISTBELT

WARNING: Do not use the apparatus if
the shackle is missing or damaged.
1. Check there is no damage or excess
wear in the bandolier and that the shackle
is securely attached to the D-ring.
necessary tighten the shackle nut.
2. Ensure that
connector is clean and in good condition.
3. Equipment that is damaged or shows
signs of excessive wear should be returned
to a Scott Safety service centre.
4. DO NOT use the equipment if it fails
any of the above checks.
5. Check the airline supply pressure
3.3
DV & FACEMASKS
1. Press the black rubber reset button
on the side of the DV.
2. Check that the red bypass switch is
turned so that the flat on the bypass switch
aligns with the DV outlet.
3. Check that the facemask is clean and
undamaged.
4. Check that the orange DV O-ring is
clean and in good condition.
5. Fit the DV to the facemask and turn it
in the facemask fitting until the red locking
catch engages fully. Twist the DV gently to
confirm that it has engaged.
If
the CEN airline
3.4

AIRLINE CHECKS

1. Check the supply airline flow and
pressure.
2. Remove connector dust caps and
check for wear and damage.
3. Make connection to an appropriate
connector capable of supplying breathable
compressed air
Compressed Airline Supplies).
4. Check that the connection is secure
and that the connector releases easily,
without sticking.
5. Press the DV reset button.
6. Pressurise the attachment and check
all connections for leaks.
attachments check
connector does not leak.
7. DO NOT use attachments that show
signs of excessive wear, or damage or that
leak excessively.
8. Replace dust caps.
4
(See Introduction,
On airline
that the female