Publicité
Les langues disponibles
Les langues disponibles
1. Remove fascia screws - Use a T15 torxbit socket to remove (2) screws from bottom edge of fascia and keep for reinstallation. See figure 2.
2. Remove existing M10 nut/washer assy – Using a 15mm deep well socket remove (2) M10 nut-washer assembly, (1 per side) from bottom of the bumper beam
attachment, see figure 1.
3. Install fasteners – Attach the 7/16" carriage bolt and ¼" thick spacer block (item 2) to the coiled end of the pull wire. Feed the other end of the pull wire through the
second access (middle) hole and bring out through the rearmost hole in the bottom of frame. Pull fasteners inside vehicle frame on both sides. See figure 3. Keep spacer
blocks and bolts inside vehicle frame while installing the Hitch, to prevent interference.
©2019 Horizon Global Americas Inc. - Printed in Mexico
Sheet 4 of 15
76300NP
6-13-19
Rev. A
Publicité
