Publicité
Les langues disponibles
Les langues disponibles
• Adjust the speed using the air regulator.
• Grip the air tool firmly with fingers and palm, then press dow the trigger and allow the tool
to run in full speed.
• Rest the sanding disc on the the workpiece (held by clamps or vise).
• For best sanding result, keep sander moving while pressing it to the workpiece with using
random motion pattern. Do not force the sander and allow it to do the work.
• When the work is done, remove the sander from the workpiece and release the trigger.
• Disconnect the air tool from air supply.
• Remove the abrasive disc.
VI. MAINTENANCE AND STORAGE
WARNING!
Before any intervention on product, always disconnect it from the air supply.
Reminder: In order to maintain the machine in good working condition, carry out regular
maintenance of the machine after each use and before storage. Any breach or inadequate
maintenance reduces the life of the machine and increases the risk of breakdowns and accidents.
6.1- Cleaning (after every use)
• Disconnect the air tool from the air supply.
• Clean the product with a soft brush or dry cloth. Do not use water or detergent for cleaning.
• Never immerse the product in water or any liquids.
6.2- Lubrication
• Lubricate the product before every use.
• Turn over the air tool and transfer a few drops of lubricating oil into the air inlet (3).
• Connect the product to air supply, then run it without load for few seconds to distribute oil
throughout the tool.
6.3- Storage
• Clean the product before storage.
• Keep product, instruction manual and accessories (if any) in the original packaging.
• Store the product in a clean environment, where is not freezing or too hot (exceed 50 ̊ C ).
• Keep out of reach of children (e.g. lock it up).
6.4- Disposal
• Do not dispose of the air tool with household garbage. Do not throw into the environment.
•
Proceed with disposal of the tool, accessories and packaging according to local regulations
regarding the protection of the environment.
Our warranty conditions are available from our STAV department [*] and on our website.
Should you have any repair requests under the warranty, please contact your retailer or our STAV
[*] who will inform you on the procedure.
Should you have any parts and/or accessories request, you can contact our STAV [*] to ask for the
product exploded view by indicating our reference and the serial number or batch number
appearing on the nameplate.
[*] STAV = Technical and After-Sales Service department
STAV contact details:
Tel : 08 92 35 05 77 (0,34€/min ; only in France) ; email :
Internet Website:
www.ribimex.com
Ribimex, 56 Route de Paris, F-77340 Pontault-Combault.
sav@ribimex.fr
Page 11 / 17
Publicité
