Publicité
Les langues disponibles
Les langues disponibles
Device Status
Standby mode
The gun has been fired.
The gun is charging
CP fault
Overpressure and underpressure
The PE cable is not connected
The emergency stop switch is pressed
Equipment overcurrent
Short circuit of equipment
Electrical leakage of equipment
Equipment overtemperature
Adhesion of equipment
5. 0 The Display is black (LED indicator is off)
Cause: The AC inlet switch is not closed, and the AC inlet switch is
tripping.
Solution: Close the AC incoming wire switch again. If it trips all the time,
please check whether the wiring of the equipment is correct and the L or N
wire is connected to the PE terminal.
5.1 Dead Screen Symptom， no response occurs when you click the display
System failure:system delay or crash.
Solution: Press the emergency stop button of the device, and then turn
the emergency stop button clockwise after about 5 seconds; If the display
COMMON PROBLEMS AND SOLUTIONS
Three-color indicator status (green light:
standby, yellow light: charging, red light:
failure)
Green light steady on
Steady yellow light
Yellow light flashing
The red light is on
The red light blinks once for 1S
The red light blinks once for 2S
The red light 4S blinks once
The red light is on for 3S and then off
for 3S
The red light is on for 5 seconds and
then off for 5 seconds
The green and yellow lights blink once,
1S
The green and yellow lights flash once
for 2S
Green and yellow light 4S blink once
- 20 -
Publicité
