Emerson InSinkErator C1300 Installation Et Utilisation page 9

PROBLEM
Water and steam spits • Unit is boiling.
forcefully from spout
May be normal during initial setup.
without turning on the
dispenser faucet.
Water is not hot. • The unit may not be plugged in.
• The electric outlet is inoperative.
Water is too hot • Thermostat is not adjusted to
or not hot enough. your needs.
Water comes out the • Outlet tube is blocked.
vent instead of spout.
Water is dripping from • The expansion chamber isn't draining
the spout/vent properly due to low water pressure.
intermittently.
• The spout is blocked.
Water is dripping • Debris in the water line may be
from the spout/vent in the faucet valve seat causing a
constantly. slow water leak.
Divided stream. • Debris in the faucet lines.
visit www.insinkerator.com or call 1-800-845-8345.
An instant hot water dispenser, like any water heater, has a limited life and will eventually fail. To avoid
possible property damage, this instant hot water dispenser should be regularly examined for leakage and
replaced when necessary. A drain pan, plumbed to an appropriate drain or outfitted with a leak detector,
should be used in those applications where any leakage could cause property damage.
All manuals and user guides at all-guides.com
TROUBLESHOOTING
POSSIBLE CAUSE
If you are still experiencing trouble,
WHAT TO DO
• Activate faucet lever to release some water from
the tank.
• Adjust water temperature using dial on tank front.
Remember that at higher altitudes, water boils
at lower temperatures.
• Make sure the unit is connected to a properly grounded
electric outlet.
• Make sure the circuit breaker or fuses are
functioning properly.
• Check that the outlet is not switched off.
• Adjust the thermostat slowly, then activate faucet handle for 20
seconds to bring in fresh water to be heated at the new setting.
Allow 5-7 minutes for water to reach new temperature.
• Check that outlet tube is not kinked, twisted or pinched.
• Unscrew spout end piece and clean out any debris.
• Unplug the unit. If the dripping doesn't stop after a few
minutes, check the supply valve to ensure that is fully
open and there are no obstructions in the water line
reducing the pressure below 30 psi ( i.e., a poorly mounted
saddle valve, a clogged water filter, or a partially opened
shut-off valve).
• Unscrew spout end piece and clean out any debris.
• Unscrew spout end piece and clean out any debris.
• Activate faucet lever 7-10 times to flush faucet & lines.
• Unscrew spout end piece and clean out any debris.
9