GYS SPOT LIFT PRO Mode D'emploi page 14

CONTROLS AND MAINTENANCE
The SPOT LIFT PRO does not require any special maintenance. A simple periodic visula control is recommended in order to prevent
any breakdown or failure during use. If a check up is needed, it must be done with no-load.
Grease scissorrs seals on a regular basis.
Check regularly that airchambers are not damaged. If so, you will need to replace them.
Clean the SPOT LIFT PRO at least once a week in order to eliminate all the dust and dirt which could alter the function of the pro-
duct on the long term. Use auto cleaning cloths. Do not use any water nor flammable or corrosive liquids.
Repairs must be done only by a qualified person. Spare parts (see p3) are available from GYS.
Any product which looks damage, is not working properly or with missing items, must be put out of service as soon as possible.
Do not use the product if some parts are broken, bent or damaged.
TROUBLESHOOTING
The chart below indicates the issues that can be observed during the use of the product. If the problem observed does not appear
in the table below, stop using the product and call immediately your distributor in order to know the procedure to follow.
TROUBLESHOOTING
The joystick is activated but the product
does not lift up.
Air leaks during the lifting.
The product goes down by itself when
the joystick is on its initial position.
The products stops while doing down.
TECHNICAL FEATURES
Maximum vehicle load
Maximum lifting height
Maximum height, when in lowest position
Product width
Product length
Weight with accessories
Recommended air pressure
Minimum air pressure
Maximum air pressure
PNEUMATIC CIRCUIT
14
SPOT LIFT PRO
Excessive load
Insufficient air pressure for the load.
Security valve faulty
Air pressure too important
Check that airchambers are not brea-
ched.
Leak inside the pneumatic circuit
There are obstacles between scissors of
the machine.
4 2
5 1 3
CAUSES REMEDIES
Check vehicle's weight and follow manu-
facturer instructions.
Check that the air input is between 6 and
9 bar.
Make sure the air pipe is not tangled.
Change safety valve
Adjust air pressure (9 bar max)
Change airchambers.
Check the air circuit, connexions and
pneumatic command.
Remove the obstacle.
2500 kg
60 cm
14 cm
60 cm
140 cm
120 kg
8 bar
6 bar
9 bar
1
EN