Publicité
Les langues disponibles
Les langues disponibles
14. CARE (
'
)
CONT
D
Grease Drip Rail
The grease drip rail should be cleaned frequently. Wash with clean cloth soaked in warm detergent solution. Wash more often if your
cooking style generates greater grease like frying foods or wok cooking.
Blower Cleaning
Access the blower and use vacuum to clean. Do not immerse in water.
Hood cleaning
Stainless steel cleaning:
Do:
• Regularly wash with clean cloth or rag soaked with warm water
and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after cleaning.
Wipe dry completely.
• You may also use a specialized household stainless steel
cleaner.
Avoid when choosing a detergent:
- Any cleaners that contain bleach will attack stainless steel.
- Any products containing: chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.
- Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc., are highly explosive and should never be
used close to a range.
15. OPERATION
BLOWER
The blower is operated using two controls.
Use the on/off rocker switch (1) to start and stop the blower. When turned ON, the
switch turns red and the blower operates at the speed set by the speed control
knob (2).
Turn the speed control knob clockwise to increase blower speed – counterclockwise
to decrease speed.
COOKTOP LIGHTING (HALOGEN)
Use the on/off rocker switch (3) to turn the halogen lights ON or OFF.
HEAT SENTRY™
This hood is equipped with a Heat Sentry™ thermostat. This thermostat is a device that will turn on the blower to high speed if it senses
excessive heat above the cooking surface.
1) If blower is OFF - it turns blower ON to high speed.
2) If blower is already ON it sets blower on high speed.
!
The HEAT SENTRY can start the blower during a range
top fire or other excessive heat situations even if the
hood is turned off. In this case, it is impossible to turn the
blower OFF using control panel switch. To stop the blower,
disconnect blower cord plug (A).
When the temperature level drops to normal, the blower will return to its original setting.
WARNING
Don't:
• Use any steel or stainless steel wool or any other scrapers to
remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction residues reach the
hood. During construction/renovation, cover the hood to make
sure no dust sticks to stainless steel surface.
2
1
HC0060
1) ON/OFF blower switch
2) Blower speed control knob
3) Halogen light switch
HE0078
10
3
A
Publicité
