Mirolin Cari CF2006 Manuel D'utilisation page 3

STEP 1: Unpack carton, leave as much of the protective
film on the acrylic tub as possible until the installation
finishes to minimize marking of the tub during installation.
STEP 3: To disassemble the bathing well from the apron
of the bathtub, invert the tub. Using a screw driver or drill,
remove the 4 screws holding the 2 tub pieces together.
SCREW LOCATIONS
STEP 5: Install faucet on the tub deck if required.
STEP 2: Position the tub in the area where it will be
installed. Unscrew the drain pop-up and mark drain
location.
STEP 4: Separate bathing well from the apron; pull apart
bathing well from the apron section as shown.
STEP 6: Reassemble bathing well with apron ensuring the
apron cut out is on the waste and overflow side and
replace the screws as shown in step 3.
CUT OUT
MARK DRAIN LOCATION
WASTE &
OVERFLOW
3