Troubleshooting - Carson BLUSTER 250 se Mode D'emploi

q. Troubleshooting
GB
Please read this before something happens.
Problem
The model does not
move
Motor does not turn
The model reacts
incorrectly to the control
commands or flies
choppily
The model does not take
off
The rotors do not allow
shut down
The model vibrates
severely
The tail does not permit
stabilizing
22 CARSON 3D Helicopter Bluster 250se 50 050 7028
Cause
1. Check whether the transmitter and the receiver are
switched on
2. Check the battery voltage of transmitter and
receiver
3. Check whether transmitter and receiver frequency
agree
4. The trim slider of the pitch-function stands on the
upper stop
1. Motor is defective
2. Connection of controller and motor is loose
1. Check the state of the transmitter and receiver
battery charges
2. Transmitter antenna not completely withdrawn
3. Receiver antenna still wound up
4. Interference
1. Pitch value is not right.
2. Batteries are empty
Trim is not correctly adjusted
1. Check whether the principal rotors run true
2. Check whether the model is correctly balanced
1. One or more rotor blades are defective
2. Lower and upper rotor revolution run with different
friction on the rotor shaft
3. The gyroscope is not adjusted correctly or is faulty.
Reparation
Switch transmitter and/or receiver on
Employ completely charged batteries
Possibly exchange the crystal
Ensure that the trim slider of the pitch
function is in neutral position or somewhat
below.
Exchange the motor
Connect the connector
Employ completely charged batteries
Extend the transmitter antenna totally
Unwind the receiver antenna completely
Make certain that there is no frequency
superposition by other transmitters and no
atmospheric disturbances
Check pitch value.
Charge the batteries or exchange them
Correct the trim on the pitch controller
Possibly balance the rotor blades
Possibly balance the rotor blades
Replace one or both rotor blades
Ensure that both rotor revolutions allow for
easy rotation
Re-adjust or replace the gyroscope.