Declaration Of Conformity - Beta 3006 Notice D'utilisation Et Instructions

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
ASSEMBLY
Assemble the hydraulic jack, installing the wheels on the central base and the side cross pieces. Fix the side cross pieces to the
central base of the hydraulic jack, and place the roller tables on the side cross pieces.
Mount the safety lever; then adjust its height.
Fit the levers into the relevant seats.
The hydraulic jack comes complete with all parts, including screws and nuts.
USE
Lift and/or position the wheels as follows:
• Unlock the safety pin on the base of the hydraulic jack.
• Fit the removable lever into the seat of the pumping piston.
• Bring the hydraulic jack near the wheel to handle.
• Widen or narrow the hydraulic jack according to the dimensions of the wheel as follows:
- to widen the hydraulic jack, pump with the lever, keeping the pedal pressed
- to narrow the hydraulic jack, pump with the lever, without pressing the pedal.
• Lock the safety pin on the base of the hydraulic jack.
• Place the hydraulic jack under the wheel; as the roller tables are free, they will adjust to the wheel perfectly.
• Lock the wheels of the hydraulic jack as well, for improved firmness.
• Position the safety arm by locking the wheel. This will secure the load, thereby preventing the wheel from falling.
• The safety arm can be adjusted vertically, and the angle can also be changed, to adjust to the different configuration of
the wheel.
• To handle the hydraulic jack, unlock the wheels, and move the hydraulic jack away, making sure that the load is steady.
• To make the hydraulic jack easier to handle, fit the removable lever into one of the seats on the base of the hydraulic jack.
Lubrication
The pneumatic tool must be connected to a filter-lubricator unit (we recommend Beta item 1919F1/4) provided with an air-oil
microfog mixer, set at two drops per minute. This will result in a high-performing tool and wear-resistant mechanical parts.
If lubrication is not provided to the line, oil ISO 32 must be periodically poured into the pneumatic tool, through the air supply
hole (picture 5-e).
MAINTENANCE
Maintenance and repair jobs must be carried out by trained personnel. For such jobs, you can contact Beta Utensili S.P.A.'s
repair centre.
DISPOSAL
The hydraulic jack as well as the accessories and packaging must be sent to a waste disposal centre, in accordance with the
laws in force your country.
This device is manufactured and tested in accordance with current EU regulations. It is covered by a 12-month
warranty for professional use or a 24-month warranty for nonprofessional use.
We will repair any breakdowns caused by material or manufacturing defects by fixing the defective pieces or
replacing them at our discretion. Should assistance be required once or several times during the warranty period,
the expiry date of this warranty will remain unchanged. This warranty will not cover defects due to wear, misuse or
breakdowns caused by blows and/or falls. This warranty will no longer be valid if any changes are made, or if the
pneumatic tool is forced or sent to the customer service in pieces. This warranty explicitly excludes any damage
to people and/or things, whether direct or consequential.
We hereby declare, assuming full responsibility, that the described product complies with all the relevant provisions
of Machine Directive 2006/42/EC and amendments thereto, as well as with the following standard:
• EN 1494
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845 Sovico (MB)
ITALIA
WARRANTY

DECLARATION OF CONFORMITY


EN I
9