Publicité
Les langues disponibles
Les langues disponibles
STEP 1: Unpack carton, leave as much of the protective
film on the acrylic tub as possible until the installation
finishes to minimize marking of the tub during installation.
STEP 3: To disassemble the bathing well from the apron
of the bathtub, invert the tub. Using a screw driver or drill,
remove the 4 screws holding the 2 tub pieces together.
SCREW LOCATIONS
STEP 5: Install faucet on the tub deck if required.
STEP 2: Position the tub in the area where it will be
installed. Unscrew the drain pop-up and mark drain
location.
MARK DRAIN LOCATION
STEP 4: Separate bathing well from the apron; pull apart
bathing well from the apron section as shown.
STEP 6: Reassemble bathing well with apron ensuring the
apron cut out is on the waste and overflow side and
replace the screws as shown in step 3.
CUT OUT
WASTE &
OVERFLOW
3
Publicité
