Dirt Devil Maxima Mode D'emploi page 28

3 Operating
1
2
2
3
1
28
1. Push on the desired nozzle, ZChapter 2.2, "Assembly"
or ZChapter 2.3, "Using other nozzles (accessories)".
2. Remove the cable, by holding the plug, until the yellow
mark is reached (Fig. 11/1).
WARNING:
If the red mark (Fig. 11/2) is visible, use the cable retract
button (Fig. 12/3) to draw in the cable again up to the
yellow mark. Otherwise the cable can break off. There is
Fig. 11
a risk of electric shock.
3. Switch on the cylinder vacuum cleaner using the on/off
switch (Fig. 12/1).
4. Turn on the suction using the suction controller
(Fig. 12/2).
5. Adjust the carpet/hard floor switch (Fig. 13) depending
1
on the type of flooring:
Fig. 12
- Hard floor (Fig. 13/A)
Laminate flooring, tiles, PVC flooring, etc.
- Carpet (Fig. 13/B)
Long and short pile carpets, runners, etc.
A
6. To vacuum, pull the cylinder vacuum cleaner behind
you like a sledge. Observe the corresponding
recommendations of the flooring manufacturer.
B
NOTE:
Fig. 13
You can quickly reduce the suction power with the
secondary air controller (Fig. 14/1) if less suction power
is required or e. g. to release objects that have been
sucked in.
Fig. 14