Get Started - Monacor Fantastic Prime RTX4 Manuel De L'utilisateur

Get started

Stick one side of the included double side sticky gel mounting strip to
the bottom of transceiver. Mount transceiver to a fl at and clean surface.
Avoid placing transceiver behind the TV or any audio device. Caution:
The transceiver may fall down if you attach it to the side of a TV or
something similar. In this case, please use a high-duty glue pad.
Plug the included Micro USB cable into any powered USB port and the
charging port on the rear of the transceiver.
Select your choice of mode (TX/RX) by sliding the toggle switch situated
on the rear of transceiver. The LED light will start fl ashing alternately
red/blue (OPT) or red/green (AUX) indicating the unit is switched „ON"
and set to pairing mode. To switch off transceiver, slide the TX/RX toggle
switch to the „OFF" position.
Transmit mode (TX) operation
Pairing with a Bluetooth receiver (e.g. headphone, home stereo,
speaker, car audio)
1. Connect the transceiver to an audio source (such as a television,
video game system, computer, MP3 player) and the transceiver
(connector „Audio In") using a jack or Toslink cable.
2. With transceiver powered on and TX/RX toggle switch set to „TX".
If the LED light is not fl ashing alternately, slide and hold the spring-
loaded slider (Multi-Function Switch) all the way to the right for about
4 seconds until the LED indicator light will fl ash red and blue.
3. Place your Bluetooth receiver within 1 meter range of transceiver and
set it into pairing mode. Transceiver and your Bluetooth receiver have
to be in pairing mode simultaneously in order to pair. Once paired, the
LED indicator will turn solid blue or green.
4. Make sure the proper audio input source is selected on the
transceiver. Match the corresponding audio input on the transceiver
by selecting between Optical and AUX audio source using the multi-
function switch.
5. The sound from your audio source will now play through your
Bluetooth receiver.
GB
2