Before You Begin; Prerequisites; First Steps - PEAKnx DoorBird Connect Notice Abrégée

Before you begin...

Before you begin...
The following guide will show you how to set up a DoorBird IP Video door station in connection
with a PEAKnx touch panel.

Prerequisites

PEAKnx panel and Doorbird station must be on the same network and have internet access.
■
YOUVI software must be set up on the PEAKnx panel and the door station module must be
■
installed. Find out more about the YOUVI setup

First steps

1. Check if the Doorbird station is online: Enter
the browser. Log in with the associated MAC address and token. You can find these on the
Digital Passport delivered with the station. The local IP address of your DoorBird IP Video
door station is available on the same page. This will be required later for the video stream
link in the YOUVI door station setup:
2. Check the YOUVI network status, this will show the network status „Connected" if an IP has
been successfully assigned in the network.
3. Install the YOUVI door station module under YOUVI Configuration > Dashboard, this requi-
res an internet connection:
here.
https://www.doorbird.com/checkonline into
21