Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Diagram A -
Connections
9
Inspection
Prior to EACH use, inspect Swivel Anchor
for deficiencies, including, but not limited
to, corrosion, deformation, pits, burrs, rough
surfaces, sharp edges, cracking, rust, paint
build-up, excessive heating, alteration, broken
stitching, fraying, and missing or illegible labels.
IMMEDIATELY remove Swivel Anchor from
service if defects or damage are found, or if
exposed to forces of fall arrest.
Ensure that applicable work area is free of all
damage, including, but not limited to, debris,
rot, rust, decay, cracking, and hazardous
materials. Ensure that work area will support the
application-specific minimum loads set forth in
this manual. Work area MUST be stable.
At least every 12 months, a Competent Person
(CP) other than the user must inspect Swivel
Anchor.
See Inspection Log on page 10
Inspections MUST be recorded in inspection
log in instruction manual and on equipment
inspection grid label. The CP must sign their
initials in the box corresponding to the month and
year the inspection took place.
During inspection, consider all applications and
hazards the harness has been subjected to.
Product lifetime is indefinite as long as it passes
pre-use and CP inspections.
This inspection log must be specific to one Swivel
Anchor. Separate inspection logs must be used
for each Swivel Anchor. All inspection records
must be made visible and available to all users at
all times. If equipment fails inspection it must be
discarded immediately.
Publicité
Table des Matières
