Assembly And Use - Guardian G2-102BX1 Mode D'emploi Et Garantie

ASSEMBLY AND USE

READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THIS CHAIR.
1. Place seat upside down on work surface.
2. Place cross bar B into diagonal seat channel and cross bar A perpendicular
over B in other seat channel. (Figure 1)
3. Use the Allen hex tool to attach the four screws securing the seat to the
frame. (Figure 2)
4. Secure middle screw with washer into the middle position on frame and
seat. (Figure 3)
5. Secure middle screw on frame using Allen hex tool and wrench. (Figure 4)
6. Slide first leg into frame, adjust to height, then insert C-Clip into pre-drilled
holes. Repeat for each leg at same height. (Figure 5)
7. Begin assembling the backrest by placing it frontside down on the
assembled seat. Line up each backrest tube and secure to the seat using
2 screws with washers on each tube. (Figure 6)
8. Lie the assembled seat on the floor with the round tube brackets facing up.
Slide the assembled backrest tubes into the tube brackets (Figure 7) and
secure using 2 C-Clips in holes closest to the back of the seat. (Figure 8)
Stand up seat, make sure all fasteners are secure, and adjust leg height if
needed.
ADJUSTING LEG HEIGHT
1. To adjust leg height, remove C-Clip from adjustment hole, set leg to
desired height and return U-clip into adjustment hole. Make sure C-Clip
clicks securely into place.
2. Repeat for remaining legs making sure all are locked into place at the
same height.
3. Push down and pull up on each leg to be sure legs are locked into place.
Before using the seat, make sure all legs are set to the same preferred height.
CAUTION: Maximum weight limit for this chair is 550 lbs (249 kg).
MAINTENANCE
Periodic visual inspection of this bath chair is recommended to ensure that all
parts and hardware are secure, that components are in good working order
and not worn, torn, frayed, or loose, and that there are no obstructions or
impediments to normal, safe operation. If any part or mechanism appears to
be unsafe or damaged, do not use the product. If you experience problems,
please contact Medline at 1-800-MEDLINE
NOTE: To maintain appearance and promote good hygiene, clean periodically
with mild soap and rinse with warm water. Wipe bath chair dry after each use.
G2-102BX1 (PIC-00303)
REVISED: V1 010423