Publicité
Les langues disponibles
Les langues disponibles
User Manual
Installation
Important! If you want to lay cables inside a cable duct or through a wall, please test your Cat.5e/6 cables
in a test installation at the highest desired resolution/colour space/colour depth combination with the
extender BEFORE you install them in your wall or cable duct!
The following steps are for an installation using HDMI equipment, if you are using DVI equipment, please
substitute the HDMI cables for DVI to HDMI cables where required.
1. Connect your HDMI source to the Transmitter unit using a HDMI cable (maximum length 3m).
2. Connect one end of the CAT5e/6 cable (max. length 50m) to the CAT port on the Transmitter and the
other end to the CAT port of the Receiver. Use solid core installation cable of at least Cat.5e UTP.
3. Set the EQ on the Receiver to the setting which matches the Cat.5e/6 cable length (see table below),
either the Primary or Secondary may be used depending on picture and cable quality.
Cable
Length
Under 15m
(49.5ft)
15 – 30m
(49.5 – 99ft)
4. Use another HDMI cable (maximum length 3m) to connect your HDMI display device to the HDMI
output port on the Receiver unit.
5. An additional HDMI display can be connected to the HDMI Out port of the Transmitter if required.
6. Set the EDID Switch according to your requirement, to the right uses the EDID from the display
connected to the Transmitter, to the left uses the EDID from the display connected to the Receiver.
7. For additional Infrared remote signal functionality, connect the
included IR Extension Cables to the Transmitter and Receiver
units, using the IR Emitter with the IR Out port and the IR Receiver
with the IR In port.
8. Place the IR Emitter in front of the IR Port of the equipment you
want to control, and ensure you place the IR Receiver in a location
where it may easily receive the signal of your IR remote.
9. Power on your HDMI Source and Display to complete the installation.
10. Finally plug the DC power supply into the Transmitter unit, the Power LED will illuminate on both units.
Troubleshooting
There is no display on the screen.
▪
Check that the DC plug and jack used by external power supply is firmly connected and that the Power
LED on both the Transmitter and Receiver are illuminated.
▪
Check that the CAT5e/6 cable is seated correctly and that the Lock LED on is illuminated.
▪
Power off all the devices, then power on in this order: first, the Transmitter unit, followed by the
display(s) and finally the source.
▪
For some HDMI devices it may be helpful to unplug and replug their HDMI connection to re-initiate the
HDMI handshake and recognition.
▪
Check that the EQ setting matches the Cat.5e/6 cable length being used. If the primary EQ setting
does not work, please try the secondary setting for the length of Cat.5e/6 cable being used.
▪
Reduce the length of CAT5e/6 or HDMI cable used, or use a higher quality cable.
Primary
Secondary
Setting
Setting
Cable
Primary
Length
Setting
30 – 40m
(99 – 132ft)
40 – 50m
(132 – 164ft)
IR Receiver
English
Secondary
Setting
IR Emitter
Publicité
