Lindy 38144 Manuel Utilisateur page 5

User Manual
Overview
Transmitter Unit
1. HDMI In – Connect to an HDMI source device, such as Media Player or Blu-ray player.
2. EDID Switch – Locate the switch to the right to copy the EDID information from the display connected
to the HDMI Out port of the Transmitter or to the left to copy the EDID information from the display
connected to the Receiver.
3. HDMI Out – Connect to an HDMI display to for local monitoring or to create an additional viewing zone.
4. IR Out – Connect the supplied IR Emitter cable and place the other end of the cable in line of sight of
the IR port of the device to be controlled.
5. Power LED – Illuminates when the Transmitter unit is receiving power.
6. CAT – Connect a Cat.5e/6 cable of up to 50m to this port and the corresponding port on the Receiver.
7. LINK LED – Illuminates when the Transmitter is receiving a signal from the HDMI source.
8. DC5V – Connect the supplied 5V power supply to power the Transmitter and Receiver units.
Receiver Unit
1. EQ – Set the EQ dip switches to the corresponding setting for the length of Cat.5e/6 cable you are
using. Please refer to the Installation section for further information.
2. HDMI Out – Connect to an HDMI display or projector.
3. IR IN – Connect the supplied IR Receiver cable and place the other end of the cable in a location where
it is in line of sight of the IR remote control to be used.
4. Power LED – Illuminates when the Receiver unit is receiving power from the Transmitter via the PoC
feature.
5. CAT – Connect a Cat.5e/6 cable of up to 50m to this port and the corresponding port on the Transmitter.
6. Lock LED – Illuminates when a stable HDMI signal is being received from the Transmitter.
English