PURE Evoke Mio Mode D'emploi page 18

Using a ChargePAK
ChargePAK E1 is an optional rechargeable battery pack which plugs into the socket
in the radio's battery compartment. Whenever your radio is connected to a mains
supply, the ChargePAK will be charging and the power remaining will be available to
view as a percentage in the Information display options (see page 7).
To purchase a Pure ChargePAK E1, contact your nearest Pure dealer or visit the shop
on our website at www.pure.com.
Installing a ChargePAK
1. Switch Evoke Mio off and disconnect from the mains power supply.
2. Turn Evoke Mio over and use a coin to unlock and remove the battery
compartment door (A).
3. Push the ChargePAK connector plug into the socket in the compartment. Line
up the ridges on the plug with the slots in the socket (B). Do not force the plug.
4. Insert ChargePAK into the battery compartment (C).
5. Replace and re-lock the battery door and connect your product to a power
supply.
6. ChargePAK will begin charging. When charging your ChargePAK for the first
time or after an extended period of inactivity we recommend that you charge it
for around 24 hours to ensure full battery power. If ChargePAK is flat there may
be a slight delay before the battery charging indicator is displayed.
(A)
General notes for use
It is perfectly normal for your ChargePAK to get warm to the touch in use, especially
during charging. Your ChargePAK should give years of trouble-free use under normal
circumstances, however, as for all rechargeable batteries the operating life will
gradually reduce with age.
To purchase additional Pure ChargePAKs, contact your nearest Pure dealer, visit the
shop on our website at www.pure.com.
Important: Evoke Mio can only be powered with a ChargePAK E1 and is not
compatible with any other batteries, either disposable or rechargeable, or any other
ChargePAK model.
16
(B) (C)