PURE Evoke Mio Mode D'emploi page 12

01 hours 00 mins
01 hours 25 mins
Timers cleared
Sleep off
45 minutes
08:30
Timers cleared
10
Setting the kitchen timer
Evoke Mio has a countdown timer which will sound an
alarm after a set time period.
To set the kitchen timer
1. Press the Timer button, turn the Tune dial and
push to select 'Kitchen timer'.
2. Turn the Tune dial to change the hours and push
to confirm. Turn again to change the minutes and
push to confirm and start the countdown timer.
The alarm will sound after the time period you have
set whether the radio is on or in standby. Cancel
the beeping alarm tone by pressing any button on
the radio.
To stop and reset the kitchen timer
To stop and reset the countdown timer to zero before it
sounds a beeping tone, press and hold down the Timer
button for three seconds until you see the message
'Timers cleared'.
Setting the sleep timer
Evoke Mio has a sleep timer that switches your radio
into standby (or off if powered by a ChargePAK) after a
set time period.
To set the sleep timer
1. Press the Timer button, turn the Tune dial and
push to select 'Sleep timer'
2. Turn the Tune dial to increase the duration of the
sleep timer from 15 to 90 minutes in fifteen minute
45
intervals. Press the Tune dial to start the sleep
timer.
The time remaining until shut-down is displayed on
the right of the full-screen time view.
To cancel the sleep timer
Press and hold the Timer button until you see the
message 'Timers cleared'.