Remote Control Instructions; Timer Setup - Uberhaus PH-891 Guide De L'utilisateur

Chaufferette en bois carrée
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The desired temperature will set and execute after the LED display stops flashing and displays again the Room
temperature
. This is your ideal setting. The heater will keep LOW
temperature is 1 degree lower and 2 degrees higher than the set temperature in order to keep the space warm
enough. The heater will turn OFF when the room temperature is 3 degrees higher than the set temperature,
and will start automatically when the room temperature drops below 2 degrees than the set temperature.
1) If your Room temp is 2°C (or more) less than the Set temperature, output power is HIGH
times.
2) If your Room temperature is between 1°C less than the Set temp and 2°C above the Set temperature,
the output power will automatically adjust from HIGH
3) If your Room temperature reaches 3°C above the Set temperature then the heater will stop heating.
The default temperature setting is preset from the factory at 21 degrees Celsius.
6. For more efficient heating, please try placing the heater a few feet above the floor in rooms with large area.
Make sure the heater is secure and won't fall.

REMOTE CONTROL INSTRUCTIONS

The buttons of the remote control will function in the same manner as the buttons on the control panel in front of
the heater; you can set the timer by using the remote control.

Timer Setup

1. Press the TIMER button until the Set Time starts flashing. The default value is 3 hours.
+
2. Press the "
" button to increase the set time or the "
from 1 hour to 12 hours. The timer will set and execute after the LED display stops flashing. The heater will
shut OFF automatically when the set time is reached.
3. To turn the timer OFF, follow step 1 and press the "–" button to set the timer to 0. The timer feature will turn off
when the LED display stops flashing.
to LOW
" button to decrease the set time. The timer can be set
6
heating output when room
.
at all

Publicité

Table des Matières
loading

Table des Matières