PRO-POINT 9040361 Mode D'emploi page 16

9040361
WARNING! Only qualified service personnel should
repair the tool. An improperly repaired tool may
present a hazard to the user and/or others.
WARNING! The use of accessories and attachments is
not recommended and may result in injury.
Grinding wheels that are used with this tool should meet with the
following specifications:
• Rated for 3,600 RPM or higher
• Width of 1 in.
• Diameter of 6 in.
• Arbor hole of 1/2 in.
• Use only balanced wheels
CAUTION! Using a wheel that is less than 3/4 in.
wide will cause vibration and could damage the
tool.
This tool comes with a diamond-based wheel dresser to keep your
grinding wheels both clean and square.
To dress the grinding wheel, accomplish the
following (Fig 11).
1. Bring the dresser (Fig. 11-1) forward on the
tool rest until it just touches the high point on
the face of the grinding wheel (B).
2. Dress the wheel by moving the dresser back
and forth.
3. Repeat this operation until the face of the
grinding wheel is clean and the edges are
square.
16
6 in. Variable-Speed Bench Grinder
For technical questions call 1-800-665-8685
V1.0
Fig. 11