System Address; Multi Tool Operation - BCTINT iVAC Pro Tool Plus Mode D'emploi

7 System Address

A System consists of up to eight 'Tool Plus' units that can control one 'iVAC Pro Switch'
By means of the Program Switch, the 'Tool Plus' can be assigned to work on one of four
System Addresses, A, B, C or D.
The System Address is to enable up to four systems to operate independently while within
communication range of each other.
All units required to operate as a System must be set to the same System Address.
System Address
A *
B
C
D

8 Multi Tool Operation

The 'iVAC Pro' System has been designed so that up to eight 'Tool Plus' units can
communicate with one 'iVAC Pro Switch' on the same System Address.
Several 'Tool Plus' units can be in operation at the same time.
The first 'Tool Plus' unit to turn on, will turn on the 'iVAC Pro Switch'. The last 'Tool
Plus' unit to turn off, will turn off the 'iVAC Pro Switch'.
TP User Guide
S1 S2
off off
on off
off on
on on
*
factory setting
9