System Test; 13 'Tool Plus' Features - BCTINT iVAC Pro Tool Plus Mode D'emploi

12 System Test

Turn off the power tool.
Set the Mode Switch to AUTO.
Turn the power tool on.
The Activity LED should flash for approximately three seconds and then go to an on state.
Turn the power tool off.
The Activity LED should flash for approximately three seconds and then go to an off state.
At this point the 'Tool Plus' should be communicating with the 'iVAC Pro Switch' that in
turn controls the dust collector.

13 'Tool Plus' Features

Plastic housing is 3.75" x 2.5" x 1.75" (95 x 63.5 x 44.5 mm) ABS 94V0 plastics.
Input power cord is 10 ft (3 m) long with a USB power plug.
Three Modes of operation. AUTO – OFF - ON
Programmable System Address.
Programmable Tool Address.
Preset able Sensitivity.
Activity LED.
TP User Guide 14