BCTINT iVAC Pro Tool Plus Mode D'emploi page 13

The rear Clamp Cover has three positions for mounting, to accommodate various sizes of
power cord diameter.
The Mode Switch is set to OFF. The Sensitivity Control is set to mid point.
The power to the power tool is turned on.
If the 'Tool Plus' is detecting the current flow then the Activity LED will turn on.
If the Activity LED does not turn on, then the Sensitivity Control should be adjusted
counter clockwise until the Activity LED turns on.
If the Activity LED does not come on, then the 'Tool Plus' should be rotated slowly around
the cable or moved along the cable until the Activity LED comes on.
At this point tighten the clamp to the cable.
The Sensitivity Control should now be set to a fully clockwise position. It should then be
rotated slowly clockwise.
Initially the Activity LED will start to flash at a slow rate and then increase until the
Activity LED is on permanently. As soon as the Activity LED is on permanently this is the
correct setting for this power tool.
Ensure the rear clamp is screwed firmly to the Tool Plus.
NOTE: For medium and higher Power Tools (Power Tools of more than 200 watts) the
Sensitivity Control set to mid point should be fine. For lower Power Tools the Sensitivity
Control should be adjusted fully counter clockwise and then move or rotate the Tool Plus
until the Activity LED comes on.
TP User Guide 13