Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
E
28
7.
Appendix B: Parameter form sheet
Switching point settings
Switching point 1
Switching hysteresis 1
Switching point 2
Switching hysteresis 2
Basic settings
Switching direction relay 1
Switching delay relay 1
Switch-back delay relay 1
Switching direction relay 2
Switching delay relay 2
Switch-back delay relay 2
Primary display
Display filter
Analogue output signal
Software version
Measuring range settings
Decimal point position
Lower measuring range limit
Upper measuring range limit
Notes
Note:
Take a copy of this sheet and fill in your required settings. You can
keep this form sheet near your manual so that you can refer to the
particular setting options at the same time. Do not commence
programming of the EDS 601 until you are sure about all the
settings. This is especially important in the case of complex settings.
This sheet can also be used for documentation purposes.
S.P.1
HYS.1
S.P.2
HYS.2
REL. 1
T. ON.
1
T. OF.
1
REL. 2
T. ON.
2
T. OF.
2
PRIM.
DISP.
OUTP.
VERS.
(unalterable)
POIN.
RAN.L.
RAN.H.
EDS 601
Serial number:
Date:
Installation site:
Publicité
Chapitres
Table des Matières
