Brush Replacement; Accessories - RIDGID R7121 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MAINTENANCE

bRUSH REPLACEMENT

See Figure 13, page 15.
The drill has externally accessible brush assemblies that
should be periodically checked for wear.

ACCESSORIES

Look for these accessories where you purchased this product.
 Mixing Wands
 High Speed Bits .................................................................................................................................1/2 in. (13 mm) Max.
 Wood Boring Bits ............................................................................................................................1-1/2 in. (38 mm) Max.
 Self Feed Bit ..................................................................................................................................2-9/16 in. (65 mm) Max.
 Auger Bit .........................................................................................................................................1-1/2 in. (38 mm) Max.
 Hole Saw, Steel ..................................................................................................................................... 3 in. (76 mm) Max.
 Hole Saw, Wood .................................................................................................................................. 5 in. (127 mm) Max.
WARNING:
Current attachments and accessories available for use with this product are listed above. Do not use any
attachments or accessories not recommended by manufacturer of this product. The use of attachments or
accessories not recommended can result in serious personal injury
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 14
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
Follow these steps to replace the brushes:
 Unplug the drill.
 Remove the brush cap with a flat blade screwdriver. The
brush assembly is spring loaded and will pop out when
you remove the brush cap.
 Remove the brush assembly (brush and spring).
 Check for wear. If worn, always replace in pairs.
Do not replace one side without replacing the other.
12 - English

Publicité

Table des Matières
loading

Table des Matières