Functional Description; Removing/Inserting The Battery; Typical Operation - Milwaukee 2787-20 Manuel De L'utilisateur

FUNCTIONAL DESCRIPTION

3
4
5
6
1. Slide rail
2. Carrying handle
3. Steel tie-off ring
(2788-20 only)
4. Feed handle
5. Battery bay
6. Magnet activation knob
7. Speed selector
8. Motor adjustment lever
9. Cutting fluid valve
10. Cutting fluid bracket
11
12
13
14
15
2
1
11. Cutting fluid bottle
12. ON(I) / OFF(O) switch
13. Drill motor
14. Cutting fluid fitting
15. Quick-change arbor
16. Safety strap bracket
(strap not shown)
17. Magnetic base
18. LED button
10
9
8
18
16 17
WARNING
cific charging instructions, read the operator's
manual supplied with your charger and battery.

Removing/Inserting the Battery

To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
may be hazardous.
Attaching Feed Handle
1. Line up the anvil and slide the handle into place
on the desired side of the tool.
2. To remove, press the center button and pull the
handle away from the tool.
Do not use a wrench, pipe, or any other lever in place
of the feed handle.
Motor adjustment lever
The motor adjustment lever is used to raise and lower
the motor on the slide rail. Always hold the motor
7
securely before loosening the adjustment lever.
Installing the Cutting Fluid Bottle
1. Ensure the valve is in the off (sideways) position.
2. Fill the bottle with HAWG WASH
3. Attach the bottle bracket to the drill.
4. Attach the hose to the fitting on the side of the drill.
WARNING
ries. Only use accessories specifically recom-
mended for this tool. Others may be hazardous.
To reduce the risk of injury, always wear proper
eye protection marked to comply with ANSI Z87.1.
1. Check the work surface to make sure it is clean
and free of foreign materials.
Paint, rust, scale or uneven surfaces decrease the
holding strength of the magnet. Chips, burrs, dirt
and other foreign materials on the surface of the
magnetic base will also decrease holding power.
Use a smooth, flat file to keep the magnet clean
and free of nicks.
The drill attaches magnetically to 1/4" or thick-
er ferrous stock. Do not use on stock less
than 1/4". The magnetic base WILL NOT hold
on nonmagnetic grades of stainless steel.
2. To install/remove cutter:
A. Remove battery pack.
B. Raise the drill motor to its highest position on
the slide rail.
C. Twist the quick-change arbor. Insert the cutter
into the arbor and release collar. Tug on cutter
to ensure it is secure. Cutter should be fully
seated into spindle.
D. Reverse procedure to remove cutter.
NOTE: Do not remove cutter unless slug is
removed. Slug may eject unexpectedly. Avoid
contact with cutter tips. Periodically inspect the
cutter tips for loose or damaged tips.
4
ASSEMBLY
Recharge only with the charger
specified for the battery. For spe-
Always remove battery pack before
changing or removing accessories.
Only use accessories specifically
recommended for this tool. Others
®
OPERATION
Always remove battery pack before
changing or removing accesso-

Typical Operation

cutting fluid.