Timer Operation - Hiyasu ASE 18UB Manuel D'instructions

06Manual 2Hiyasu Eng 7/4/06

TIMER Operation

Set Clock correctly before starting Timer operation
You can let unit start or stop automatically at following times: Before you wake up
in the morning, or get back from outside or after you fall asleep at night.
TIMER ON/OFF
(1)After unit start, select your desired operation mode.
Power indicator on indoor unit lights up. Operation mode will be displayed on LCD.
(2)TIMET mode selection
Press TIMER button to change TIMER mode.
Every time the button is pressed, display changes as follows:
Select your desired TIMER mode (TIMER ON or TIMER
OFF) ON or OFF will flash.
3)Timer setting
Press HOUR /
Every time the button is pressed, time increases 10 min.
If button is kept depressed, time will change quickly.
Every time the button is pressed, time decreases 10 min.
If button is kept depressed, time will change quickly. Time
will be shown on LCD. It can be adjusted within 24 hours.
(4)Confirming your setting
Timer mode indicator on indoor unit lights up.
After setting correct time, press SET button to confirm, "ON" or "OFF" stops flas-
hing
Time displayed: Unit starts or stops at x hour x min. (TIMER ON or TIMER OFF).
To cancel TIMER mode
Just press TIMER button several times until TIMER mode disappears.
Hints
After replacing batteries or a power failure happens, Time setting should be
reset.
Remote controller possesses memory function, when use TIMER mode next
time, just press SET button after mode selecting if timer setting is the same as
previous one.
All manuals and user guides at all-guides.com
09:22 Página 69
OPERATION
button.
69