Operation - Hiyasu ASE 18UB Manuel D'instructions

06Manual 2Hiyasu Eng 7/4/06
Remote controller's operation
• When in use, put the signal transmission head directly to the receiver hole on
the indoor unit.
• The distance between the signal transmission head and the receiver hole
should be within 7 m without any obstacle as well.
• Don't throw the controller, prevent it from being damaged.
• When electronic-started type fluorescent lamp or change-over type fluorescent
lamp or wireless telephone is installed in the room, the receiver is apt to be dis-
turbed in receivering the signals so the distance to the indoor unit should be
shorter.
Loading of the battery
Load the batteries as illustrated. 2 R-03 batteries,
resetting key (cylinder)
Remove the battery cover:
Slightly press " " and push down the cover.
Load the battery:
Be sure that the loading is in line with the" + "/"-"
pole request as illustrated.
Put on the cover again
Confirmation indicator:
In disorderation, reload the batteries or load the new batteries after 6 mins.
Use two new same-typed batteries when loading.
Note:
If the remote controller can't run normally or doesn't work at all, use a sharp
pointed item to press the reset key.
Hint:
Remove the batteries in case unit won't be in usage for a long period.
If there are any display after taking-out just need to press reset key.
Power failure resume(please set and apply as necessary)
If sudden power failure occurs, the unit will resume original operation when power
is supplied again.
When sudden power failure happens during unit operation in power failure
Note:
resume mode, if the air conditioner is not desired for use in a long period, please shut
off the power supply in case that the unit automatically resume operation when power
is re-supplied, or press ON/OFF to turn off the unit when power resumes.
All manuals and user guides at all-guides.com
09:22 Página 65

OPERATION

65