Publicité
Les langues disponibles
Les langues disponibles
AttAchment to WAlker
1. Remove angle adjustment knobs and washers
from armrest. Assemble by inserting bolts through
post mounting bracket. Add washers and tighten
knobs (Figure 1).
2. Insert handle for right or left hand use so that the
armrest is on the inside of the walker (Figure 2).
tighten knobs slightly.
3. With the post to the outside of the walker, center
metal plates on top of upper and lower spreader
bars (Figures 3 & 4). Tighten post mounting knobs so
that platform attachment is securely in place.
4. Adjust handle to desired length and tighten
armrest knobs securely.
5. Angle of armrest can be adjusted using the angle
adjustment knobs (Figure 5). Consult your medical
professional for proper adjustment.
6. Make sure all knobs are tightened and platform
attachment is securely fitted to walker.
GriP cleAninG instructions
Clean the grips with a mild soap, detergent or
household cleaner. Do not use an organic solvent
(such as acetone, MEK, lacquer thinner, lighter
fluid, dry cleaning fluid, gasoline or turpentine) that
may dissolve the plastic and cause the grip to loosen.
G-MDS86615P (GPI116)
Revised: 4/8/10
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
3
Publicité
