TypeS BT56208 Directives D'utilisation Et D'entretien page 8

C) RAISED INSTALLATION – FOR TRUCKS & SUV WITH STEP BUMPERS
(This will raise the camera frame out of the cavity of the step bumper)
1. Unscrew and remove your license plate.
3. Finally, install the Quick-Connect Wireless
Backup Cam and license plate onto the
rear of your vehicle and tighten the
Mounting Nuts with a wrench.
Warning: Lower tailgate on pickup trucks slowly and check for minimum ¼ inch clearance between
gate and top of camera frame. This check is because some bumpers are installed higher than others.
8
2. Install the Two Way Mounting Tabs using
original Plates Screws and Mounting Screws.
Mounting
Screw
Step Bumper
Original Plate Screw
Two Way Mounting
Mounting Tab Nut