Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PAIRING
The HD Quick-Connect Wireless Backup Cam included is already paired with the Monitor. If you can
not see the Camera image, pair the Camera with the following steps:
1.
Power on the HD Quick-Connect Wireless Backup Cam
2.
To enter Pairing Mode, press and hold the Power Button under the camera for 5 seconds, or
until the LED flashes continuously. The camera will remain in Pairing Mode for one minute.
3.
On the Monitor:
Press "Menu"
Go to "Pair Camera"
Press "Parking Aid line" to confirm
The unit is now in pair mode - if the Monitor is able to connect with the camera, the display
will show "Pair OK".
If no camera is found, then the display will show "Pair Fail". In this case, cut off power and reboot
the Monitor. If you keep receiving the "Pair Fail" message after several attempts, please call our
technical support to assist in troubleshooting.
10
Publicité
Table des Matières
