Midas HD96-24-CC-TP Guide De Démarrage Rapide page 13

24
HD96-24-CC-TP
HD96-24 Basic Operation
Direct connection of I/O
DL153 connected at
FOH for extra local I/O
Direct connection of
HD96-24 to DL231
I/O rach via Cat5e
To power up the system
Important Note:
Make sure your speaker system, in-ears or monitor wedges are muted until the start-up of the system has been completed.
Connect mains cables to each PSU. Apply
power to the surface via the AC/POWER
switch for each PSU. Note the surface can
function on 1 PSU if required.
After all system interconnections have been made, start up the system by doing the following:
Switching on the HD96-24
1. Plug the two mains cables into the mains power outlets. Both power supply modules should be supplying power to the
HD96-24 surface for correct redundant operation.
2. Plug the connectors of the mains cables into the IEC mains sockets on the rear of the HD96-2
3. Turn on the power to the HD96-24 surface by switching both AC POWER switches on. The surface will boot up.
Once the default GUI screen is displayed, it is ready for use.
To switch off the HD96-24 surface
1. Make sure you have saved any shows, scenes or settings you require.
2. In the GUI, select Menu from the top bar, then press and hold the red
SHUTDOWN button at the bottom of the menu until the line traces around the outside of the red button. The shutdown procedure will then initiate.
3. The screen will go blank, the Midas logo will briefly be displayed, then the screen will go blank for a second time indicating the shutdown procedure has finished.
Only once the system has been shutdown correctly is it safe to turn off both AC power switches (rear of surface).
25
Quick Start Guide