Télécharger Imprimer la page

Nax Power Products 500C Manuel D'utilisation page 49

Masquer les pouces Voir aussi pour 500C:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 98
TROUBLESHOOTING
Problem
Difficulties in starting a cold
engine.
The equipment goes out and it
is difficult to restart.
Low engine acceleration speed
and poor cutting power.
Idle speed is not stable.
CAUTION! If the device requires further maintenance, please contact the NAX Central Service.
WARRANTY AND SERVICE
The product purchased by you is intended for amateur (hobby) use only. If the equipment is used for other purposes (commercial,
professional), it will lose the guarantor's liability for the purchased equipment. You can find information on the warranty and the NAX
service network in the attached warranty card.
Remember that the machine should be cleaned after each use. Keeping the equipment clean will ensure long-term and reliable
operation. Cleaning, maintenance and periodic inspections are not repairs. Authorized NAX services may perform these activities as
part of a paid service.
DEVICE ASSEMBLY DIAGRAMS
Assembly diagrams of the device are on pages 9 and 10.
Possible cause
Low fuel.
Spark plug flooded or damaged.
No spark on the spark plug.
No suction attached.
Contaminated air filter
The fuel mix has run out.
Carburettor clogged.
Ignition switch off.
Too much carbon deposits have
accumulated on the spark plug.
Clogged / dirty fuel filter.
Choke enabled.
Clogged cylinder cooler, too much soot
has accumulated in the top of the cylinder.
Oil circulation blocked and / or air filter
blocked.
Weak or tight chain.
Dirty air filter.
The fuel pin is too tight and / or the stop
screw is incorrectly adjusted.
The fuel pin is too tight and / or the oil is
too thick.
Water or dirt in the fuel system.
Check the fuel level and add fuel if necessary.
Check, clean or replace the spark plug.
Replace the spark plug with a new one.
See the chapter: Starting the engine.
Clean or replace the filter.
Clean the carburettor.
Turn off the switch.
Clean carbon deposit collected on the spark plug.
Clean the cylinder.
Adjust and / or sharpen.
Have it adjusted at the garden tools service. An
authorized NAX service is recommended.
Have it adjusted at the garden tools service. An
authorized NAX service is recommended.
Change the fuel, and if it does not help - have it
repaired by qualified service.
EN
Solution
Fill the fuel tank.
Replace it.
Turn off choke.
Clean
Clean or replace
49

Publicité

loading

Produits Connexes pour Nax Power Products 500C