Change To The Edging Mode; Pivoting Head Function; Adjust The Length Of The Shaft; Maintenance - GreenWorks STA806 Manuel D'opérateur

• Do not force the trimmer head into uncut grass.
• Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood can
wear the cutting line quickly.
DIRECTION
OF
ROTATION
9.7

CHANGE TO THE EDGING MODE

You can change the trimmer to an edger to keep patios,
driveways and sidewalks well groomed.
1. Stop the machine.
2. Push on the edge button (1) and turn the trimmer head 90
degrees until the trimmer head locks into position.
°90
1
3. Release the edge button.
9.8

PIVOTING HEAD FUNCTION

Adjust pivoting head to trim areas which are hard to reach
and for users to operate comfortably.
1. Stop the machine.
2. Push on the pivoting button and turn the shaft until the
trimmer head locks into required position.
DANGEROUS
CUTTING AREA
BEST CUTTING
AREA
NOTE
NOTE
English
3. Release the pivoting button.
9.9 ADJUST THE LENGTH OF THE
SHAFT
You can adjust the length of the shaft to operate the
machine easily.
1. Stop the machine.
2. Unlock the cam lever and move the lower shaft to the
desired position.
3. Lock the cam lever.
10

MAINTENANCE

Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight. Examine
regularly that you install the handles tightly.
Use only the replacement parts and accessories of the initial
manufacturer.
9
ADJUST(2)
PRESS(1)
NOTE
1
IMPORTANT
IMPORTANT
IMPORTANT
EN