General Information; Clean The Machine; Replace The Spool - GreenWorks STA806 Manuel D'opérateur

EN
10.1

GENERAL INFORMATION

Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Store the machine in cool and dry place.
• Use correct clothing, protective gloves and safety glasses.
10.2

CLEAN THE MACHINE

• Clean the machine after use with a moist cloth dipped in
neutral detergent.
• Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
• Keep the trimmer head free of grass, leaves, or excessive
grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
• Do not spray water onto the motor and electrical
components.
10.3

REPLACE THE SPOOL

1. Push the tabs on the sides of the trimmer head at the same
time.
2. Pull and remove the spool cover.
SPOOL
COVER
IMPORTANT
TABS
SPOOL
English
3. Remove the remaining spool.
4. Put the spool in the spool housing.
Make sure that you put the cutting line in the slot on the
new spool and extend the line approximately 15 cm before
you install the new spool.
5. Put the ends of the cutting lines through the holes.
6. Extend the cutting line to release it from the guide slot in
the spool.
Line exit hole
7. Push the tabs and install the spool cover onto the spool
housing.
8. Push the spool cover until it clicks into position.
10
NOTE