Description; Purpose; Overview; Safety - GreenWorks G24LM33 Manuel Opérateur

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
1

DESCRIPTION

1.1

PURPOSE

This machine is used for domestic lawn mowing. The cutting
blade must be approximately parallel to the ground. All four
wheels must touch the ground while you mow.
1.2

OVERVIEW

Figure 1-9.
Switch box handle
1
Start button
2
Upper handle
3
Lower handle
4
Rear discharge door
5
Battery door
6
Grass catcher
7
Screw
8
Bolt
9
Grass catcher handle
10
Bracket
11
Spacer
12
Screw
13
Battery pack
14
Battery release button
15
Safety key
16
Blade
17
Spacer
18
Mounting nut
19
Height adjustment axle
20
Positioner
21
Handle knob
22
2

SAFETY

WARNING
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

WARNING
Do not change or make accessories that are not
recommended by the manufacturer.
WARNING
Do not put in the safety key or the battery pack until you
assemble all the parts.
English
3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
If the parts are damaged, do not use the machine.
If you do not have all the parts, do not operate the
machine.
If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2

INSTALL THE LOWER HANDLE

Figure 2
1. Insert the lower handle into the frame holes.
2. Put the bolts through the holes and tighten with a
screwdriver.
Do not make damage to the cables when you install the
handle.
3.3

INSTALL THE UPPER HANDLE

Figure 3
1. Align the holes in the upper handle and the lower handle.
2. Put the bolts through the holes.
3. Tighten the knobs onto the bolts.
4. Do the same operation on the other side.
3.4

INSTALL THE GRASS CATCHER

Figure 4 & 5
1. Put the four screws into the washers to attach the bracket.
2. Move the bracket into the groove.
3. Align the latches and the slots of the top and lower halves
of the grass catcher and push the two halves together to
interlock.
4. Push the latch of the handle into the grass catcher.
5. Open the rear discharge door and hold it.
6. Hold the the grass catcher by its handle and put the hooks
over the slots.
7. Close the rear discharge door.
5
WARNING
WARNING
WARNING
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Lmg301

Table des Matières