Ryobi RY08420B Guide De Démarrage

WARNING:
This Engine Starting Procedure is not a substitute for
reading the operator's manual. To reduce the risk of injury, user must
read and understand operator's manual before using this product.
50:1 Ratio = Mix 2.6 oz 2-cycle lubricant with
2.6
oz.
1 gallon of fresh gasoline in separate gas
1 GALLON
container. SHAKE. Pour into fuel tank.
GAS
IDLE
Set the cruise control lever to the START/QUIET position.
START/
QUIET
FULL
Slowly press the primer bulb 10 times.
NOTE: After the 10th press, fuel should be visible in the
primer bulb. If it is not, continue to press the primer until you
x10
see fuel in the bulb.
CHOKE
Set the choke lever to CHOKE position.
RUN
Pull starter grip and rope sharply until engine attemps to run. Do
not pull starter grip more than 5 times.
CHOKE
Set the choke lever to the RUN position .
RUN
Pull the starter grip and rope until the engine runs. Do not pull
starter grip more than 6 times.
NOTE: If engine does not not start, return to the START/QUIET
position and repeat the steps that follow.
CHOKE
Set the choke lever to the RUN position.
RUN
IDLE Set the cruise control lever to the START/QUIET position.
START/
QUIET
FULL
Pull starter grip sharply until engine attemps to run. Do not pull starter grip more than 4 times.
To Stop:
Depress the STOP switch.
ENGINE STARTING PROCEDURE
Go to www.ryobitools.com and register your new tool on-line.
For any questions about operating or maintaining your product, call the Ryobi
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator's manual.
Help Line!
™
995000178
5-11-2017 (REV:01)