Ryobi RY08420 Guide Rapide

WARNING:
This Engine Starting Procedure is not a substitute for reading
the operator's manual. To reduce the risk of injury, user must read and under-
stand operator's manual before using this product.
50:1 Ratio = Mix 2.6 oz 2-cycle lubricant with
2.6
oz. 1 gallon of fresh gasoline in separate gas
1 GALLON
container. SHAKE. Pour into fuel tank.
GAS
Slowly press the primer bulb 10 times.
NOTE: After the 10th press, fuel should be visible in the primer bulb. If it is not, continue
to press the primer until you see fuel in the bulb.
x10
Unlock the cruise control (set to Idle)
Set the choke lever to " START" position A.
Pull starter grip and rope sharply until engine attemps to run. Do
not pull starter grip more than 5 times.
Set the choke lever to the " RUN " position B.
Pull the starter grip and rope until the engine runs. Do not pull
starter grip more than 6 times.
NOTE: If engine does not not start, return to the START
position A and repeat the steps that follow.
Set the choke lever to the " RUN " position B.
Lock the cruise control (set to full throttle)
Pull starter grip sharply until engine attemps to run. Do not pull starter grip more than 4 times.
To Stop:
Depress the STOP switch to
the stop position "O" .
ENGINE STARTING PROCEDURE
Go to www.ryobitools.com and register your new tool on-line.
For any questions about operating or maintaining your product, call the Ryobi Help Line !
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator's manual.
®
990000090
9-27-12 (REV:03)