Paradigm ADP-370 Instructions D'installation

PARADIGM ADP-370 INSTALLATION INSTRUCTIONS
Read This Section Carefully Before Proceeding
Precautions: Whenever a speaker is mounted to a wall you must take special care to mount it securely to prevent it from falling and causing damage or injury. For safe and secure installation please use
good judgement and common sense throughout all phases of the installation. As an additional safety precaution use secondary restraining hardware to prevent any personal injury or damage to property.
Load: The enclosed hardware is intended for use in mounting the Paradigm ADP-370 only.
Mounting Surfaces: Carefully evaluate the composition, construction and strength of the surface on which you are mounting the speaker. The enclosed hardware is intended for use with 1/2" or 5/8" drywall,
wallboard or sheetrock only. For masonry, wood, and other solid surfaces consult with a professional regarding the proper hardware for mounting the wall bracket to the wall.
2 - sets of mounting brackets (one set per speaker) • 4 - wall anchors • 4 - short screws • 4 - long screws • 4 - rubber pads • 1- instruction sheet • 1- wall template
Installing Wall Hardware
...
into Drywall
** Use the template to mark the location of the
mounting bracket holes on the wall and to mark
the location of the speaker wire hole if running
wires inside the wall.
With a #2 Phillips screwdriver, press each E-Z-
1
TOGGLE ® firmly into wallboard and turn
clockwise until seated flush with wall.
Place bracket (with tines facing up) in position
2
over the installed E-Z-TOGGLE ® . Insert long
screws straight and begin turning to engage clamp.
NOTE: Long screws must be inserted in straight
and be fully tightened to ensure proper operation
of E-Z-TOGGLE ® .
Continue turning long screws into E-Z-TOGGLE
3
until tight. (The clamp will move forward against
the drywall as the screw is turned.)
1
1/2" or 5/8"
Drywall only
2
Ensure screw is
inserted straight
TINES
FACING UP
WARNING:
WRONG!
Angled screw
will not engage
E-Z-TOGGLE ®
3
4
TINES
FACING
DOWN
Please Note:
As an additional safety precaution
use secondary restraining hard-
ware to prevent any personal
injury or damage to property.
We are aware that this mounting assembly
could be used for purposes and in ways other
than those for which it was intended. The
Manufacturer, Distributor, Retailer, and their
respective Agents cannot be held responsible
or liable for injuries or property damage -
direct, indirect, or consequential - arising out of
the use, or inability to use this product safely
and properly.
Every effort has been made to provide accurate
and error-free installation instructions.
P E I . and AudioStream
ARADIGM LECTRONICS NC
(Division of Bavan Corporation) disclaim liability
for any difficulties arising from the interpretation
of information contained in these instructions.
E-Z-TOGGLE is a registered trademark of ITW BUILDEX. Markham, Ontario, Canada.
Each hardware package contains the required hardware for mounting one pair of speakers:
Installing Speaker Hardware
Position the other bracket to the pilot holes on the back of the speaker with the tines facing down. Fasten using short screws.
1
Fix pads to lower left and right corners of speaker.
2
3 Carefully mount the speaker on the wall allowing the speaker wire to retract into the hole in the wall. If not running wire into the wall,
fit speaker wire into the channel provided.
®
Top of speaker
Locate E-Z toggle screws for Wall Bracket Here
(with Bracket Tines facing up)
Speaker Terminal Area
If speaker wire
is to run inside
wall, cut a hole
for the left or
right hand
speaker
( 3 ⁄ ˝ [ ] diameter
19 mm
4
or more).
ADP-370 Installation Template
IN-38
REV.05.02