Care And Maintenance; Care And Cleaning Of The Dehumidifier - Emerson DFR29 Manuel De L'utilisateur

Table des Matières

Les langues disponibles

Removing the collected water

2. Continuous draining

Water can be automatically emptied into a

floor drain by attaching the unit with a water

hose(not included).

Remove the rubber plug from the back drain

hose outlet. Attach a drain hose(ID=13.5mm)

and lead it to the floor drain or a suitable

drainage facility(see Fig.7).

Make sure the hose is secure so there are no

leaks.

Direct the hose toward the drain,making sure

that there are no kinks that will stop the warter

flowing.

Place the end of the hose into the drain and

make sure the end of the hose is level or

down to let the water flow smoothly. Do never

let it up.

Make sure the water hose is lower than the

drain hose outlet.

Select the desired humidity setting and fan

speed on the unit for continuous draining to

start.

NOTE: When the continuous drain feature is

not being used, remove the drain hose from

the outlet and reinstall the rubber plug.

Care and cleaning of the dehumidifier

Turn the dehumidifier off and remove the plug

from the wall outlet before cleaning.

1. Clean the Grille and Case

Use water and a mild detergent. Do not use bleach

or abrasives.

Do not splash water directly onto the main unit. Doing

so may cause an electrical shock, cause the insulation

to deteriorate, or cause the unit to rust.

The air intake and outlet grilles get soiled easily, so use

a vacuum attachment or brush to clean.

2. Clean the bucket

Every few weeks, clean the bucket to prevent growth of mold,

mildew and bacteria. Partially fill the bucket with clean water

and add a little mild detergent. Swish it around in the bucket,

empty and rinse.

NOTE: Do not use a dishwasher to clean the bucket.

After clean, the bucket must be in place and securely

seated for the dehumidifier to operate.