Removing The Collected Water - Emerson DFR29 Manuel De L'utilisateur

OPERATING THE UNIT

Removing the collected water

There are two ways to remove collected water.
1. Use the bucket
When the bucket is full, the Full indicator light
will illuminate, the digital display shows P2.
Slowly pull out the bucket. Grip the left and right
handles securely, and carefully pull out straight so
water does not spill. Do not put the bucket on the floor
because the bottom of the bucket is uneven. Otherwise
the bucket will fall and cause the water to spill.
Throw away the water and replace the bucket. The
bucket must be in place and securely seated for the
dehumidifier to operate.
The machine will restore to its original state when the
bucket is replaced in its correct position.
NOTES:
When you remove the bucket, do not touch
any parts inside of the unit. Doing so may
damage the product. Be sure to push the
bucket gently all the way into the unit.
Banging the bucket against anything or
failing to push it in securely may cause the
unit not to operate.
When you remove the bucket, if there is some
water in the unit you must dry it .
1. Pull out the bucket a little.
2. Hold both sides of the bucket
with even strength, and pull it
out from the unit.
3. Pour the water out.
40
Fig.5
Fig.6